Видеорегистратор BlackVue DR500GW-HD c WiFi

DM36x initialization passed! TI UBL Base Version: 1.50 Boot Loader BootMode = NAND Starting NAND Copy... Valid magicnum, 0xA1ACED66, found in block 0x00000008. Boot Mode Task Completed IPNC UBL Version: 1.1.0 Platform: DM368 Jumping to entry point at 0x81080000 U-Boot 1.3.4 (Nov 23 2012 - 16:42:13) DM368-IPNC-1.1.1 I2C: ready DRAM: 256 MB NAND: NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3, 3V 8-bit) Bad block table found at page 65472, version 0x01 Bad block table found at page 65408, version 0x01 128 MiB *** Warning - bad CRC or NAND, using default environment In: serial Out: serial Err: serial ARM Clock :- 432MHz DDR Clock :- 340MHz Ethernet PHY: GENERIC @ 0x00 Press "d" or " " to abort autoboot in 1 seconds NAND read: device 0 offset 0x500000, size 0x500000 5242880 bytes read: OK ## Booting kernel from Legacy Image at 82000000 ... Image Name: Linux-2.6.18_pro500-davinci_IPNC Image Type: ARM Linux Kernel Image (uncompressed) Data Size: 2065084 Bytes = 2 MB Load Address: 80008000 Entry Point: 80008000 Verifying Checksum ... OK Loading Kernel Image ... OK OK Starting kernel ... Linux version 2.6.18_pro500-davinci_IPNC_DM368_2.6.0 (root@sejung-ubuntu) (gcc v ersion 4.2.0 (MontaVista 4.2.0-16.0.32.0801914 2008-08-30)) #1 PREEMPT Thu Jan 3 18:39:28 KST 2013 CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 Machine: DaVinci DM368 IPNC Memory policy: ECC disabled, Data cache writeback DaVinci DM0365 variant 0x8 PLL0: fixedrate: 24000000, commonrate: 170000000, vpssrate: 340000000 PLL0: vencrate_sd: 75555555, ddrrate: 340000000 mmcsdrate: 48571428 PLL1: armrate: 432000000, voicerate: 20571428, vencrate_hd: 27000000 CPU0: D VIVT write-back cache CPU0: I cache: 16384 bytes, associativity 4, 32 byte lines, 128 sets CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 sets Built 1 zonelists. Total pages: 32768 Kernel command line: mem=128M console=ttyS1,115200 root=/dev/mtdblock3 rootfstyp e=cramfs ip=off mtdparts=nand_davinci.0:0x300000(boot),0x200000(env),0x500000(ke rnel),0x3000000(rootfs),0x4000000(data1),-(data2) eth=96:a6:6c:45:e2:c0 board=DR 500T TI DaVinci EMAC: kernel boot params Ethernet address: 96:a6:6c:45:e2:c0 PID hash table entries: 1024 (order: 10, 4096 bytes) Clock event device timer0_0 configured with caps set: 07 Console: colour dummy device 80x30 Dentry cache hash table entries: 16384 (order: 4, 65536 bytes) Inode-cache hash table entries: 8192 (order: 3, 32768 bytes) Memory: 128MB = 128MB total Memory: 125312KB available (3386K code, 909K data, 188K init) Security Framework v1.0.0 initialized Capability LSM initialized Mount-cache hash table entries: 512 CPU: Testing write buffer coherency: ok NET: Registered protocol family 16 DaVinci: 104 gpio irqs MUX: initialized GPIO20 MUX: initialized I2C_SCL MUX: initialized CLKOUT1 Generic PHY: Registered new driver ch0 default output "COMPOSITE", mode "NTSC" VPBE Encoder Initialized SCSI subsystem initialized usbcore: registered new driver usbfs usbcore: registered new driver hub NET: Registered protocol family 2 IP route cache hash table entries: 1024 (order: 0, 4096 bytes) TCP established hash table entries: 4096 (order: 2, 16384 bytes) TCP bind hash table entries: 2048 (order: 1, 8192 bytes) TCP: Hash tables configured (established 4096 bind 2048) TCP reno registered VFS: Disk quotas dquot_6.5.1 Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) squashfs: version 3.1 (2006/08/19) Phillip Lougher JFFS2 version 2.2. (NAND) (SUMMARY) (C) 2001-2006 Red Hat, Inc. yaffs Jan 3 2013 18:37:21 Installing. Initializing Cryptographic API io scheduler noop registered io scheduler anticipatory registered (default) io scheduler deadline registered io scheduler cfq registered sbulla:<5>Req dev 0 dir 0 sec 0, nr 8 f 944 unknown partition table LTT : ltt-facilities init LTT : ltt-facility-core init in kernel LTT : ltt-facility-statedump init in kernel LTT : ltt-relay init ltt-control init LTT : ltt-facility-statedump init DAVINCI-WDT: DaVinci Watchdog Timer: heartbeat 60 sec Serial: 8250/16550 driver $Revision: 1.90 $ 2 ports, IRQ sharing disabled serial8250.0: ttyS0 at MMIO map 0x1c20000 mem 0xfbc20000 (irq = 40) is a 16550A serial8250.0: ttyS1 at MMIO map 0x1d06000 mem 0xfbd06000 (irq = 41) is a 16550A RAMDISK driver initialized: 1 RAM disks of 32768K size 1024 blocksize loop: loaded (max 8 devices) PPP generic driver version 2.4.2 PPP Deflate Compression module registered tun: Universal TUN/TAP device driver, 1.6 tun: (C) 1999-2004 Max Krasnyansky <maxk@qualcomm.com> rtw driver version=v3.4.3_4369.20120622 Build at: Jan 3 2013 18:38:05 usbcore: registered new driver rtl8192cu Davinci EMAC MII Bus: probed MAC address is 96:a6:6c:45:e2:c0 TI DaVinci EMAC Linux version updated 4.0 netconsole: not configured, aborting Linux video capture interface: v2.00 Trying to register davinci display video device. layer=c07dbc00,layer->video_dev=c07dbd60 Trying to register davinci display video device. layer=c07dba00,layer->video_dev=c07dbb60 davinci_init:DaVinci V4L2 Display Driver V1.0 loaded i2c /dev entries driver nand_davinci nand_davinci.0: Using 4-bit hardware ECC NAND device: Manufacturer ID: 0xec, Chip ID: 0xf1 (Samsung NAND 128MiB 3,3V 8-bi t) 6 cmdlinepart partitions found on MTD device nand_davinci.0 Creating 6 MTD partitions on "nand_davinci.0": 0x00000000-0x00300000 : "boot" 0x00300000-0x00500000 : "env" 0x00500000-0x00a00000 : "kernel" 0x00a00000-0x03a00000 : "rootfs" 0x03a00000-0x07a00000 : "data1" 0x07a00000-0x08000000 : "data2" nand_davinci nand_davinci.0: hardware revision: 2.3 musb_hdrc: version 6.0/dbg, pio, host, debug=1 musb_hdrc: USB Host mode controller at c88e6000 using PIO, IRQ 12 musb_hdrc musb_hdrc: MUSB HDRC host driver musb_hdrc musb_hdrc: new USB bus registered, assigned bus number 1 usb usb1: configuration #1 chosen from 1 choice hub 1-0:1.0: USB hub found hub 1-0:1.0: 1 port detected pcf8563 0-0051: chip found, driver version 0.4.2 pcf8563 0-0051: rtc intf: proc pcf8563 0-0051: rtc intf: dev (254:0) pcf8563 0-0051: rtc core: registered pcf8563 as rtc0 davinci-mmc davinci-mmc.0: Supporting 4-bit mode davinci-mmc davinci-mmc.0: Using DMA mode Advanced Linux Sound Architecture Driver Version 1.0.12rc1 (Thu Jun 22 13:55:50 2006 UTC). >>>[mmc_setup:1426] power_mode:MMC_POWER_OFF[0] ASoC version 0.13.1 MUX: initialized MCBSP_BDX MUX: initialized MCBSP_X MUX: initialized MCBSP_BFSX MUX: initialized MCBSP_BDR MUX: initialized MCBSP_R MUX: initialized MCBSP_BFSR wm8960: WM8960 Audio Codec 0.2 asoc: WM8960 <-> davinci-i2s mapping ok ALSA device list: #0: DaVinci DM365 WM8960 (WM8960) IPv4 over IPv4 tunneling driver GRE over IPv4 tunneling driver Initializing XFRM netlink socket NET: Registered protocol family 1 NET: Registered protocol family 17 NET: Registered protocol family 15 ieee80211: 802.11 data/management/control stack, git-1.1.13 ieee80211: Copyright (C) 2004-2005 Intel Corporation <jketreno@linux.intel.com> pcf8563 0-0051: setting the system clock to 2013-05-26 01:07:43 (1369530463) Time: timer0_1 clocksource has been installed. Clock event device timer0_0 configured with caps set: 08 Switched to high resolution mode on CPU 0 No filesystem could mount root, tried: cramfs Kernel panic - not syncing: VFS: Unable to mount root fs on unknown-block(31,3)